Cable Assembly Instruction
Clamp/Solder
	STEP 1.	All parts of the connector are shown.
	STEP2.	Strip the cable inner conductor, dielectric, braid, and jacket as per "Recommended Cable Stripping DIM'S" in the On-Line Catalogue.
	STEP 3.	First slide the Nut onto cable, then insert inner conductor into the Contact PIN and solder it, fold back braid wire as shown.
	STEP 4.	Place the Braid Clamp over braid and push back against cable jacket.
	STEP 5.	Insert cable and parts into the Main Body, then screw the Nut until it is tightened.